International Harvester 4700 1997 Recalls

Choose International Harvester 4700 1997 recall from the list:

STEERING : WHEEL AND HANDLE BAR: the steering column used was incorrectly manufactured. the tube portion of the steering column has a welded end with a specified length of 5.5 inches. a 3.5 inch welded end was used by mistake. with the shorter end, it is possible there is insufficient engagement of the male end into the tube portion and separation of the column could occur.
SUSPENSION : REAR: vehicle description: school buses and heavy duty trucks equipped with rear axle assemblies produced by dana spicer. certain rear axle assemblies were improperly heat treated which could allow pinion breakage at the pinion threads.
SEATS: on certain heavy duty trucks equipped with bostrom driver seat models 910, 910sc, or 914 and international
SUSPENSION : REAR: the drive axle housings consist of a plate steel center section and two forged spindles, one of which is welded to each end of the center section. each spindle contains a keyway slot in which the locking tab for the wheel bearing nut locking mechanism is inserted. the length of the keyway slot may not be long enough to accommodate the tab causing the tab to be deformed or damaged during installation.

Motor Pits